Astra Owners Network banner

1 - 2 of 2 Posts

·
Registered
Joined
·
166 Posts
Discussion Starter #1 (Edited)
I was exiting from this give way at the speed of 3-7 mph. I think the road maximum speed was between 5-10mph

testing223.jpg

The car hasn't been lowered and with standard set up, it somehow managed to touch the black moulding strip on the bumper when stopped on the give way line. The car does seem low but I thought it had enough ground clearance for it unable to touch the roads. I'm asking this is because I am unsure how the black moulding strip is assembled on to the car/ or bumper as I'm just concerned of it coming off as it might be an important part to the car.

36962187.jpg

forgot HAPPY XMAS everyone at AON
 

·
Moderator
Joined
·
15,092 Posts
Unless the rubber is ripped then it will just push back into place. There are tabs on the top that push into slots in the bumper and I think the corners are retained by a plastic rivet.

It's only there to make it look pretty, you could do without it if it's damaged.
 
1 - 2 of 2 Posts
Top