[dave180]

Hi
I've bought some full leather seats on the bay thinking it would be a nice easy swap, now half way through the job i'm loosing confidence.
I've only now realised that the new seats don't have pre-tensioners, which explains why the connector was apart and all the cables were loose not nice and neat.
So my questions are what wire is missing from the seat's multiplug, it's the small one second from the red clip?
Why does the drivers seat not have the white connector?
If i use my pre-tesioners with the new seat's airbag is that going to cause any problems?

I thought i'd read enough about doing this......

Thanks

 

[STEALTH]

Just use your ones mate should be fine all seats are the same setup

 

[dave180]

Thanks, they went in ok, no warning lights. Hopefully nothing else is missing when i try to get the heating working

 

[dave180]

Right, i've had a look to see where i need to add the wires to get the heated seats working, but there are pins where i was expecting nothing, since i doubt i'm that lucky, can someone point out where i should be adding thw wires?